T-Pad 600ohm attenuator 1176 DIY

Custom 600 ohm t-pad attenuator. Made from a custom 3 deck potentiometer, this unit provides the same attenuation as the original bridged t-pad found in the FET compressor with more dependability and smooth operation.

More details

Reduced price!
TPAD600ATT1176
New product
Limited special offer

12,45 €

20,75 €

-40%

14,94 €   tax incl.

Please contact us to order

Add to compare

 
More info

Custom 600 ohm t-pad attenuator. Made from a custom 3 deck potentiometer, this unit provides the same attenuation as the original bridged t-pad found in the FET compressor with more dependability and smooth operation.

  • Custom low noise high-end Modular Potentiometer
  • Module 1: Conductive Plastic Linear Element 500Ω +/-10%
  • Module 2: Conductive Plastic Logarithmic Element 1KΩ +/-10%
  • Module 3: Conductive Plastic Linear Element 500Ω +/-10%
  • Shaft/Bushing: 6.0mm shaft with bushing
  • Shaft Length: 18.0mm
  • Shaft End: Slotted
  • Terminals - Trough Hole
  • Mounting Hardware: Mounting Nut & Lockwasher
 
Data sheet
Type Attenuators
 
Support

For support, please visit our forum and the "M&M Service Point".

Write a review

T-Pad 600ohm attenuator 1176 DIY

Custom 600 ohm t-pad attenuator. Made from a custom 3 deck potentiometer, this unit provides the same attenuation as the original bridged t-pad found in the FET compressor with more dependability and smooth operation.

Write a review

30 other products in the same category:

Customers who bought this product also bought:

Compare 0

No products

To be determined Shipping
0,00 € Total

Check out